I will write up all that's gone on in the last few days but suffice to say its printing again and much better as well. It has a new nozzle which is the only change really since I have postponed the move to Marlin since it did not go well for me despite considerable help from Maik in Germany. I need to concentrate on other areas for the moment and the new ReplicatorG ver 33 looks good with dual extruder capacity, although it keeps crashing on me at the moment.
So I am back to standard firmware as supplied by Richard (SumPod owner and designer) with ReplicatorG (ver 29) and Skeinforge. However, the print I got today was the best yet! The only change is the development nozzle.
- The box printer today used for calibration
- The small box (using it now for me pills!)
- The box is slightly over size at 26.5mm as against 25mm square
- Nice layer integration
Speak Your Mind